BM-A6 Full automatic blow molding machine is suitable for producing PET plastic containers and bottles in all shapes. It is widely used to produce the carbonated bottle, mineral water, pesticide bottle oil bottle cosmetics, wide-mouth bottle and hot fill bottle etc.
|1||Blow Molding Machine||BM-A6||56KW||1set|
|2||HP Air Compressor||6.0m3/min/30Kg||66KW||1set|
|3||LP Air Compressor||1.6 m3 /min/10Kg||15KW||1set|
|4||Cold dryer(HP)||6.0 m3/min/30Kg||2KW||1set|
|5||Cold dryer(LP)||2.0 m3/min/10Kg||0.45KW||1set|
|8||High-pressure oil pipe||15m|
Features of main body:
1). Stable performance with advanced PLC.
2). Automatic preform conveyer to save human cost.
3). Preform self-rotation and infrared pre-heater revolution assure the even distribution of heat, which improve the bottle shaping rate, increase the production.
4). High adjusting performance to enable preheat the preforms perfectly by adjust the voltage control area in the PLC, which could adjust the temperature of the infrared lights in the pre-heater, and keep the proper temperature and humidity invariable.
5). High safeties with security automatic-locking device in each mechanical action, which will make the production into a perfect safe environment, in case of the breakdown in certain procedure.
6). Use SMC air cylinder to avoid contamination and noise.
7). Satisfaction with different atmospheric pressure for blowing and mechanical action by dividing the blowing and action into three parts in the air pressure diagram of the machine.
8). Strong clamping force with high pressure and double crank links to lock the mould.
9). Two ways of operating: automatic and manual.
10). Low cost,high efficiency,easy operation and maintenance etc, profited from the fully automatic technological process.
12). Ideal cooling system make the finished bottles without any flaws.
|Bottle type specification||Cavity||6|
|Bottle mouth maximum overall diameter||28-38mm|
|Bottle biggest diameter||100mm|
|Bottle maximum height||330mm|
|Power specifications||Light tube quantity||32pcs|
|Light tube power||1.5KW|
|Maximum heating power||48KW|
|All electric machine installation||55KW|
|Blow bottle pressure||25-35kg/c|
|Higher -pressure gas consumption||4000Ltr/min|
|Forzen water specification||Work pressure||5-6 kg/c|
|Forzen water flow||88L/min|
|Machine specification||Size of the machine||6.5×1.5×1.9|
|Weight of the machine||4ton|
|9||Pressure regulating table||1|
|10||Temperature control module||2|
Fuctions of the accessory machines:
Air compressor is the air source for PET stretch blow molding machine, carrying out the process of compressing air from atmosphere to the required pressure.
Air dryer is to remove the moisture from the compressed air and lower temperature of the compressed air in the heat exchanger.
Air filter is to clear up the impurities out of the compressed air, like carbon hydrogen, tiny dust and solid particles.
Air tank is to keep the air stable ,to protect the Hp air compressor.
Water Chiller is to Cool the mould ,to prolong the life of the mould.